How to install the car seat cover

Before installation of the car seat cover, first check the quality of the purchased car seat cushion and the strength and length of the stretched suture, so as to lay a good foundation for the rear installation. Usually, a set of car cushions includes five pieces: two front seats, two single backs and a long cushion in the back seat.

Installation method of car seat cover: the car front seat cushion has a hat head and cap pocket. Just cover the car seat cushion down directly, and then there are one or two buckles at the connection of the car seat cushion. You can directly insert the car seat cushion buckle into the gap of the seat by hand, so that the car seat cushion will not move forward. At this time, you can hook two small shackles in front of the paved car seat cushion into the iron bar under the seat. Some have no tongue hook, but buckle with elastic band. At this time, you should pass the buckle through one end of the buckle through the middle gap of the seat and lock it with the buckle at the other end from under the seat. In this way, the front driver's seat is installed, and the other passenger's seat is installed in the same way.

Installation of rear seat cover: first of all, please observe the installation mode of rear bench seat in the car. In fact, there are only two kinds: buckle type and non buckle type bench seat. For non pull type seat, you can directly pull out the bench seat with force. For bench seat with buckle, you can press the buckle and then pull out the bench seat. At this time, you have to disassemble the car body and fix the seat with other screws. Separate the long seat from the back rest. After the long seat of the car cushion is separated from the back rest, you can simply pass the long cushion through the bayonet on the car cushion from below and fix the long cushion. At this time, you can also put the rear backrest on the hat head of the rear seat.

Finally, after installing the bench seat, pay attention to the reset of the safety belt. You can insert the long cushion of the car seat cushion and the fixing card of the backrest into the gap, and then you can flatten the car seat cushion.